Installation Procedure

WARNING: This page is about a different car, the 2013 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery Energy Control Module Junction Block Fasteners

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the drive motor battery wire junction block relay (2) and tighten the fasteners (1) to 9 N.m (80 lb in).

Fig 2: Cut-Off Switch Fastener

Courtesy of GENERAL MOTORS COMPANY

Connect the following to the generator battery disconnect relay junction block :
- Current Sensor Connector (3).
- Pre-Charge Contacts (4).
- Contactor Connector (5).

Fig 3: Generator Control Module Connector

Courtesy of GENERAL MOTORS COMPANY

Install the connector (1) to the generator control module.

Fig 4: High Voltage Battery Cables-To-Batteries Fasteners

Courtesy of GENERAL MOTORS COMPANY

Install the fasteners (2) retaining the junction block to the generator control module.
Position the high voltage cables through the cable retaining clip (1).
Install the high voltage cables to the batteries and tighten the fasteners (3) to 9 N.m (80 lb in).
Enable the hybrid battery. Refer to High Voltage Enabling .