Multifunction Switch
WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the windshield wiper washer switch harness connector at the multifunction switch.
- With the wiper switch in the HIGH position, test for less than 2 ohms of resistance between the Windshield Wiper Switch Signal 1 terminal E and the Windshield Wiper Switch Signal 2 terminal C.
- If greater than the specified range, replace the windshield wiper washer switch.
- While cycling the wiper switch through each delay and speed position, test for the specified resistance between the Accessory Voltage terminal D and the signal 1 terminal E.
IMPORTANT:
If the switch tests open in any switch position other than Off, test the signal circuits for a short to voltage before replacing the switch.
Wiper Switch Values
| Switch Position | Resistance |
|---|---|
| Off | Infinite |
| Mist | 1780 Ω |
| Delay 1 | 2.61K Ω |
| Delay 2 | 1.87K Ω |
| Delay 3 | 1.4K Ω |
| Delay 4 | 1.02K Ω |
| Delay 5 | 750 Ω |
| Low | 1780 Ω |
| High | 1780 Ω |
- If any switch position is not within the specified range, replace the windshield wiper washer switch.