FixVault
Home › Buick › 2012 › Regal Base › Repair and Diagnosis › External Pages › Different car › Section 99 (Wiper System & Washer System) › Repair Instructions › Windshield Wiper Motor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Wiper Motor & Wiper Transmission Assembly
    GM2141571Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor to the wiper transmission assembly.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wiper motor screws. Tighten the screws to 8 N.m (71 lb in)..
    3. NOTE: The new wiper motor comes pre-timed from the factory in the PARK position. Do Not energize the wiper motor prior to installation.
    If the wiper motor is energized, the wiper motor must be electrically returned to the PARK position as shown, prior to installation.
  3. Install the wiper motor crank arm at the 3:00 o'clock (a) position to the wiper motor as shown.
  4. Install the wiper motor crank arm (1) and crank arm nut (2). Tighten the nut to 19.5 N.m (14 lb ft).
  5. Install the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement .
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
About FixVault