FixVault
Home › Buick › 2013 › Verano Base › Repair and Diagnosis › External Pages › Different car › Section 76 (Instrument Panel Trim And Console Trim) › Repair Instructions › Inflatable Restraint Instrument Panel Module Trim Cover Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Trim Cover Over Hooks
    GM2056703Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure no debris or contamination is inside the housing and airbag cushion pack.
  1. Position the trim cover (1) over the 5 hooks on the forward side of the module.
    2. Fig 2: Pivoting Trim Cover
    GM2056704Courtesy of GENERAL MOTORS CORP.
  2. Pivot the trim cover (1) over the module and slide down over the 4 hooks on the rear edge. Push the rear edge down far enough for the windows to clear the 4 hooks.
    3. Fig 3: Identifying Lower Edge Of Trim Cover
    GM2056705Courtesy of GENERAL MOTORS CORP.
  3. Ensure the lower edge of the trim cover (1) is tucked back up under the 4 hooks on the rear edge so that the cover can freely move up and down.
  4. Install the inflatable restraint instrument panel module. Refer to Instrument Panel Inflatable Restraint Module Replacement .
About FixVault