FixVault
Home › Buick › 2014 › Regal GS, FWD, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 2.0L (LTG) - Repair Instructions › Repair Instructions › Fuel Feed Intermediate Pipe Replacement

Fuel Feed Intermediate Pipe Replacement

Fig 1: Fuel Feed Intermediate Pipe
GM2809527Courtesy of GENERAL MOTORS COMPANY
Fuel Feed Intermediate Pipe Replacement

Callout Component Name
WARNING:

Refer to Gasoline/Gasoline Vapors Warning .

Preliminary Procedure

  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Remove the charge air cooler outlet air tube. Refer to Charge Air Cooler Outlet Air Tube Replacement .
  3. Remove the fuel pump cover. Refer to Fuel Pump Cover Replacement .
1 Fuel Pump Intermediate Pipe Fittings (Qty:2)
WARNING:

Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

CAUTION:

Refer to Component Fastener Tightening Caution .


Tighten 
30 N.m(22 lb ft).
2 Fuel Pump Intermediate Pipe
NOTE:

The pipe fittings are a one time use, always install a New fuel pump intermediate pipe.
About FixVault