FixVault
Home › Buick › 2016 › Cascada Base › Repair and Diagnosis › External Pages › Different car › Section 22 (Antilock Brake System) › Repair Instructions › Front Wheel Speed Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2016 Chevrolet Malibu Limited. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel speed sensor (1) to the steering knuckle.
    Fig 1: Wheel Speed Sensor And Harness Clip
    GM2278446Courtesy of GENERAL MOTORS COMPANY
  2. Install the harness clip (2) to the steering knuckle.
  3. Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
    Fig 2: Wheel Speed Sensor Bolt
    GM2278445Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  4. Connect the wheel speed sensor electrical connector (1) and secure the connector to the frame.
    Fig 3: Wheel Speed Sensor Electrical Connector & Harness Clips
    GM2278444Courtesy of GENERAL MOTORS COMPANY
  5. Install the harness clip (2) to the frame.
  6. Install the harness clips (3) to the lower control arm.
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the Diagnostic System Check - Vehicle .
About FixVault