FixVault
Home › Buick › 2016 › Envision › Repair and Diagnosis › External Pages › Different car › Section 102 (HVAC System - Automatic) › Repair Instructions › Mode Control Cam Alignment › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Buick LaCrosse. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    The HVAC module must be removed to accurately set the cam gear timing. Failure to do so may result in poor HVAC performance and/or damage to the HVAC module.

  1. Remove the HVAC module from the vehicle. Refer to Heater and Air Conditioning Evaporator and Blower Module Removal and Installation .
    2. Fig 1: View Of Mode Cam Gear Actuator, Screws & HVAC Module
    GM2323129Courtesy of GENERAL MOTORS COMPANY
  2. Remove the mode cam gear actuator screws (1) and separate the actuator (2) from the HVAC module.
  3. Disconnect the mode cam gear actuator electrical connector.
    4. Fig 2: Mode Cam Gear, Levers And Valve Gears
    GM2323133Courtesy of GENERAL MOTORS COMPANY
  4. Remove the mode cam gear (1) from the HVAC module.
  5. For alignment purposes, remove both cam gear levers (2).
  6. If the valve gears (3) are damaged, remove them from the HVAC module and discard.
About FixVault