Circuit/System Verification

• If any DTC is set 

  Refer to:Diagnostic Trouble Code (DTC) List - Vehicle

• Go to next step: If no DTC is set 

• If not the specified state 

  {If available}Refer to:Shift Indicator Indicates Wrong Gear Selection

• Go to next step: If the specified state 

Verify the scan tool parameter:

1. { Without BTM }5V Ignition Switch=Crank Request
2. Accessory=Inactive
3. { With BTM }Engine Control Module - Power Mode=Crank Request

• If not the specified state 

  Refer to:Power Mode Mismatch

• Go to next step: If the specified state 

• If the parameter value increments 

  Replace the component:B26 Crankshaft Position Sensor

• Go to next step: If the parameter value does not increment 

• If the component does not work as specified 

  Verify the following conditions do not exist:

1. Accessory drive belt component - Seized
2. Engine - Seized

• Go to next step: If the component works as specified 

Verify the component works as specified:

• M64 Starter Motor=Activated - Rotate(s)
• Engine=Cranking

• {M64 Starter Motor Rotate(s) & Starter Pinion Clicks}If the component does not work as specified 

  Refer to: Circuit/System Testing

• Go to next step: If the component works as specified