FixVault
Home › Buick › 2017 › LaCrosse Base › Repair and Diagnosis › Suspension › Electronic Suspension › Suspension Control System › Repair Instructions › Electronic Suspension Control Module Replacement › Installation Procedure

Installation Procedure

    Fig 1: Electronic Suspension Control Module And Bracket
    GM4475301Courtesy of GENERAL MOTORS COMPANY
  1. Install the electronic suspension control module (1) until it is fully seated into the electronic suspension control module bracket (2) and secured by the tab as indicated.
    2. Fig 2: Electronic Suspension Control Module
    GM4475295Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Electronic Suspension Control Module 2 - Install
  3. Electronic Suspension Control Module Bracket Nut 1 - Install and tighten 2.5 N.m (22 lb in)
  4. Electrical Connector @ Electronic Suspension Control Module - Connect
  5. Rear Compartment Side Trim @ Left Side - Install - Rear Compartment Side Trim Replacement - Left Side (With LHN)Rear Compartment Side Trim Replacement - Left Side (With LGX)
  6. Program the electronic suspension control module. Control Module References
About FixVault