Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Ball Joint to Knuckle Bolt | |
|
30 N.m (22 lb ft) |
|
60 - 75 degrees |
| Ball Joint to Knuckle Nut | |
|
30 N.m (22 lb ft) |
|
60 - 75 degrees |
| Bearing / Hub Bolt | |
|
90 N.m (66 lb ft) |
| Second Pass: | 60 degrees |
|
15 degrees |
| Front Lower Control Arm Bolt | |
|
90 N.m (66 lb ft) |
|
75 - 90 degrees |
| Front Lower Control Arm Nut | |
|
90 N.m (66 lb ft) |
|
75 - 90 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | |
|
22 N.m (16 lb ft) |
|
30 degrees |
| Intermediate Steering Shaft Bolt | 34 N.m (25 lb ft) |
| Lower Control Arm Rear Bushing Bolt | |
|
55 N.m (41 lb ft) |
| Second Pass: | 45 degrees |
|
60 degrees |
| Rear Lower Control Arm Bushing Bolt | |
|
70 N.m (52 lb ft) |
|
75 - 90 degrees |
| Rear Lower Control Arm Bushing Nut | |
|
70 N.m (52 lb ft) |
|
75 - 90 degrees |
| Steering Knuckle Bolt | |
|
90 N.m (66 lb ft) |
|
60 - 70 degrees |
| Steering Knuckle Nut | |
|
90 N.m (66 lb ft) |
|
60 - 70 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Frame Rear Bolt | 160 N.m (118 lb ft) |
| Front Transmission Mount Bolt | 58 N.m (43 lb ft) |
| Lower Stabilizer Link Shaft Nut | 65 N.m (48 lb ft) |
| Rear Transmission Mount Bracket Bolt | 100 N.m (74 lb ft) |
| Stabilizer Shaft Link Nut | 65 N.m (48 lb ft) |
| Strut Nut | 70 N.m (52 lb ft) |
| Upper Strut Mount Nut | 45 N.m (33 lb ft) |
| Wheel Speed Sensor Screw | 6 N.m (53 lb in) |