Fastener Specifications (2.0L LTG)
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Engine Coolant Air Bleed Pipe O-Ring |
| Engine Coolant Thermostat Housing Seal |
| Thermostat Bypass Pipe Gasket |
| Turbocharger Coolant Feed Pipe Copper Washer |
| Turbocharger Coolant Feed Pipe Gasket |
| Turbocharger Coolant Return Pipe Washer |
| Water Outlet Seal |
| Water Pump Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Engine Coolant Air Bleed Pipe Bolt | 9 N.m (80 lb in) |
| Engine Coolant Fan Shroud Bolt | 5.1 N.m (45 lb in) |
| Engine Coolant Heater | 50 N.m (37 lb ft) |
| Engine Coolant Thermostat Housing Bolt | 10 N.m (89 lb in) |
| Front Bumper Shutter Bolt | 2.5 N.m (22 lb in) |
| Ground Cable Nut | 9 N.m (80 lb in) |
| Radiator Air Lower Baffle Bolt | 2.5 N.m (22 lb in) |
| Radiator Surge Tank Bolt | 9 N.m (80 lb in) |
| Radiator Upper Bracket Nut | 7 N.m (62 lb in) |
| Radiator Upper Mount Bracket Bolt | 7 N.m (62 lb in) |
| Thermostat Bypass Pipe Bolt | 10 N.m (89 lb in) |
| Transmission Fluid Cooler Pipe Bolt | 5.1 N.m (45 lb in) |
| Turbocharger Coolant Feed Pipe Fastener | 10 N.m (89 lb in) |
| Turbocharger Coolant Feed Pipe Hollow Screw | 35 N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Banjo Bolt | 35 N.m (26 lb ft) |
| Turbocharger Coolant Return Pipe Bracket Bolt | 10 N.m (89 lb in) |
| Water Outlet Fastener | 12 N.m (106 lb in) |
| Water Pump Bolt | 25 N.m (18 lb ft) |