FixVault

Fastener Specifications (3.6L LGX)

WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application
Engine Coolant Air Bleed Pipe Seal
Engine Coolant Thermostat Housing Seal
Heater Inlet and Outlet Pipe Gasket
Water Pump Gasket
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. 

Application Specification
Metric (English)
Water Pump Bolt 15 N.m (11 lb ft)
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal. 

Application Specification
Metric (English)
Engine Coolant Air Bleed Pipe Bolt 10 N.m (89 lb in)
Engine Coolant Fan Bolt 9 N.m (80 lb in)
Engine Coolant Fan Motor Bolt 6 N.m (53 lb in)
Engine Coolant Outlet Pipe Bracket Bolt 10 N.m (89 lb in)
Ground Nut 9 N.m (80 lb in)
Heater Inlet and Outlet Pipe Bolt 9 N.m (80 lb in)
Radiator Air Lower Deflector Bolt 2.5 N.m (22 lb in)
Radiator Surge Tank Bolt 9 N.m (80 lb in)
Radiator Upper Bracket Bolt 7 N.m (62 lb in)
Radiator Upper Bracket Nut 7 N.m (62 lb in)
Water Outlet Bolt 10 N.m (89 lb in)
Water Pump Inlet Pipe Bolt 15 N.m (11 lb ft)
Water Pump Pulley Bolt 10 N.m (89 lb in)