Fastener Specifications
WARNING: This page is about a different car, the 2020 Buick Regal TourX, 2020 Buick Regal, 2019 Buick Regal TourX, and 2019 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Front Bolt | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Lower Control Arm Rear Bolt | Torque mating fastener |
| Front Wheel Bearing and Hub Assembly Bolt | |
|
100 N.m (74 lb ft) |
|
60 - 75 degrees |
| Steering Knuckle Bolt @ Strut Assembly | Torque mating fastener |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Lower Control Arm Rear Nut | |
|
100 N.m (74 lb ft) |
|
90 - 105 degrees |
| Front Stabilizer Shaft Insulator Clamp Bolt | 22 N.m (16 lb ft) |
| Front Stabilizer Shaft Link Nut | 100 N.m (74 lb ft) |
| Front Strut Rod Mount Nut | 70 N.m (52 lb ft) |
| Steering Knuckle Nut @ Front Lower Control Arm | |
|
40 N.m (30 lb ft) |
|
120 - 135 degrees |
| Steering Knuckle Nut @ Strut Assembly | |
|
100 N.m (74 lb ft) |
|
45 - 60 degrees |