Fastener Specifications
WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| CV Boot Clamp |
| Front Wheel Drive Intermediate Shaft Bearing Retainer Ring |
| Front Wheel Drive Intermediate Shaft O-Ring |
| Front Wheel Drive Intermediate Shaft Retaining Ring |
| Wheel Drive Shaft Retaining Ring |
| Wheel Drive Shaft Washer |
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Wheel Drive Shaft Nut | |
| First Pass: | 50 N.m (37 lb ft) |
| Final Pass: | 60 degrees |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Front Wheel Drive Intermediate Shaft Bolt | 58 N.m (43 lb ft) |
| Front Wheel Drive Intermediate Shaft Flange Bolt | 22 N.m (16 lb ft) |
| Rear Wheel Drive Shaft Bolt | 58 N.m (43 lb ft) |