FixVault
Home › Buick › 2019 › Encore Base › Repair and Diagnosis › External Pages › Different car › Section 88 (Immobilizer System) › Diagnostic Information and Procedures › DTC B3902 › Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2018 Chevrolet Trax and 2018 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the Programming and Setup procedure for the control module that set DTC B3902.
    NOTE:

    When performing the following step, Immobilizer System Component Programming, the module may also need to be reset by using the SPS function Prepare For Removal.

  2. Perform the Immobilizer System Component Programming Immobilizer System Component Programming .
  3. Verify DTC B3902 does not set after programming.
    • If the DTC sets after programming 

      Replace the control module that set the DTC.

    • Go to next step: If the DTC does not set after programming 
  4. All OK.
About FixVault