FixVault
Home › Buick › 2019 › Envision Base › Repair and Diagnosis › External Pages › Different car › Section 37 (Disc Brake System) › Repair Instructions › Rear Brake Caliper Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 Buick Envision. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM3829329Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper (1) - Install

  2. GM3829327Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Brake Caliper Guide Pin Bolt (1) - Install [2x] 25 N.m (18 lb ft)

  3. GM3829322Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper Guide Pin Seal (1) - Install [2x]

  4. GM3829314Courtesy of GENERAL MOTORS COMPANY

    Brake Caliper Spring (1) - Install

  5. GM3829310Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install NEW brake hose fitting gaskets.

    Brake Hose Fitting Gasket (1) [2x] @ Brake Hose Fitting (2) - Install

  6. GM3829302Courtesy of GENERAL MOTORS COMPANY

    Brake Hose Fitting Bolt (1) - Install 40 N.m (30 lb ft)

  7. Connect the electronic parking brake actuator electrical connector.
  8. Bleed the brake system. Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure)
  9. Install the tire and wheel assembly. Tire and Wheel Removal and Installation
About FixVault