Circuit/System Verification
WARNING: This page is about a different car, the 2018 Buick Regal TourX and 2018 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode
- Verify the component works as specified:Cruise Control Switch Assembly
- Refer to:Body Control Module-Scan Tool Parameters in Typical Scan Tool Data
- If a condition exists
Refer to Circuit/System Testing .
- Go to next step: If no condition exists
- If a condition exists
- Verify the condition does not exist:Cruise Control System Status=Inhibit by ECM
- Cruise Control System Status=Inhibit by ECM
If a condition exists - Repair or replace as necessary
- Go to next step: Cruise Control System Status Inhibit by ECM
- Cruise Control System Status=Inhibit by ECM
- Verify that no DTC listed in the DTC Descriptor Category is set.
- If a related DTC is set
Refer to Circuit/System Testing .
- Go to next step: If a related DTC is not set
- If a related DTC is set
- All OK.