Electronic Brake Traction Control Module (EBTCM): Installation

WARNING: This page is about a different car, the 1999 Cadillac Catera and 1998 Cadillac Catera. However, it is still accessible from the selected car via links, so may be relevant.

To install, clean BPMV gasket surface with alcohol. Install 2 NEW wave springs in original location and position between EBTCM and BPMV. Install EBTCM to BPMV. Install 4 NEW top mounting screws and tighten in an "X" pattern to 26 INCH lbs. (2.9 N.m). Install 2 NEW bottom screws and tighten to 26 INCH lbs. (2.9 N.m).
Connect pump motor connector at bottom of EBTCM. Connect EBTCM harness connector and push in lock tab. Install lower radiator hose to engine. Install ECM into relay center and install relay center cover. Turn ignition on, with engine off. Perform DIAGNOSTIC SYSTEM CHECK under DIAGNOSIS & TESTING.