Installation Procedure

CAUTION: When you are carrying an undeployed inflator module:

Do not carry the inflator module by the wires or connector on the inflator module
Make sure the bag opening points away from you

When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

Fig 1: Inflatable Restraint Steering Wheel Module Connector

Courtesy of GENERAL MOTORS CORP.

Install the module
Connect the module electrical connector
NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems

Fig 2: Torx® screws

Courtesy of GENERAL MOTORS CORP.

Install the Torx® screws. Tighten the screws to 8 N.m (72 lb in).
Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM