FixVault
Home › Cadillac › 2001 › Seville SLS › Repair and Diagnosis › External Pages › Different car › Section 249 (Supplemental Inflatable Restraint System) › Repair Instructions › SIR Disabling and Enabling Zone 5 › Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Inflatable Restraint I/P Module Connector
    GM217468Courtesy of GENERAL MOTORS CORP.
  1. Remove the key from the ignition switch.
  2. Connect the inflatable restraint I/P module connector located at the base of the steering column.
  3. Install the CPA to the I/P module coil connector located at the base of the steering column.
    4. Fig 2: I/P Fuse Block & SDM Fuse
    GM68610Courtesy of GENERAL MOTORS CORP.
  4. Install the left sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  5. Install the SDM Fuse to the I/P fuse block.
  6. Install the front floor kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
  7. Staying well away from both air bags, turn the ignition switch to the ON position.
    1. The AIR BAG indicator will flash seven times.
    2. The AIR BAG indicator will then turn OFF.
  8. Perform the Diagnostic System Check - SIR  if the AIR BAG indicator does not operate as described.
About FixVault