FixVault
Home › Cadillac › 2002 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 428 (Rear Wheel Steering System) › Removal & Installation › Rear Wheel Steering Control Module › Installation

Rear Wheel Steering Control Module: Installation

WARNING: This page is about a different car, the 2002 GMC Yukon, 2002 Chevrolet Tahoe, and 2002 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the control module to the vehicle.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the control module (2) retaining bolts (1). Tighten to specifications. See TORQUE SPECIFICATIONS TABLE .
  3. Connect the electrical connectors to the module.
  4. Install the spare tire to the vehicle.
  5. Lower the vehicle.
  6. Perform a learn alignment.
About FixVault