Window Adjustment - Door

CAUTION: Refer to GLASS & SHEET METAL HANDLING CAUTION in Cautions and Notices.

CAUTION: Refer to EXPRESS WINDOW DOWN CAUTION in Cautions and Notices.

Remove the door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE FRONT DOOR or TRIM PANEL REPLACEMENT - SIDE REAR DOOR .
Pull down the upper portion of the water deflector far enough to access the window clamp nuts. Refer to WATER DEFLECTOR REPLACEMENT - FRONT DOOR or WATER DEFLECTOR REPLACEMENT - REAR DOOR .
Loosen the window regulator to window clamp nuts 4 revolutions.
Connect the door trim panel wire connector.

Fig 1: Adjustment Of Door Window
Courtesy of GENERAL MOTORS CORP.

Important: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.
Start the vehicle.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Using the power window switch, raise the window to the full up position.
Tighten

Tighten the window clamp nuts to 11 N.m (98 lb in).
Inspect for proper window operation and a tight seal.
Shut off the vehicle.
Install the water deflector. Refer to WATER DEFLECTOR REPLACEMENT - FRONT DOOR or WATER DEFLECTOR REPLACEMENT - REAR DOOR .
Install the door trim panel. Refer to TRIM PANEL REPLACEMENT - SIDE FRONT DOOR or TRIM PANEL REPLACEMENT - SIDE REAR DOOR .