FixVault
Home › Cadillac › 2003 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 366 (Wiper System & Washer System) › Repair Instructions › Wiper Motor Cover Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the cover (4) to the wiper motor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 4 screws (3) to the cover.

    Tighten:  Tighten the 4 screws equally to 2.6 N.m (23 lb in).

  3. Connect the electrical connector (2) and install the CPA.
    4. Fig 1: CPA Connector Electrical Connector, Motor Cover & Screws
    GM1510196Courtesy of GENERAL MOTORS CORP.
  4. Install the air inlet panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
  5. Install the wiper arms. Refer to Wiper Arm Replacement .
  6. Install the radio antenna. Refer to Fixed Antenna Replacement in Entertainment.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) or Battery Negative Cable Disconnect/Connect Procedure (Auxiliary Battery) in Engine Electrical.
  8. Close the hood.
About FixVault