FixVault
Home › Cadillac › 2003 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 468 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Front End Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
    2. Fig 1: View Of Front End Sensor Connector & Frame Crossmember
    GM859932Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the electrical connector.
  3. Remove the connector position assurance (CPA) from the connector.
  4. Remove the sensor bolt.
  5. Remove the sensor (2) from the vehicle.
About FixVault