FixVault
Home › Cadillac › 2003 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 468 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Connector Position Assurance (CPA) & Side Impact Sensor Yellow 2-Way Connector
    GM612189Courtesy of GENERAL MOTORS CORP.
  1. Connect the inflatable restraint side impact sensor yellow 2-way harness connector (5) to the inflatable restraint side impact sensor (1).
  2. Install the CPA (3) to the inflatable restraint side impact sensor yellow 2-way connector (5).
  3. Install the inflatable restraint side impact sensor (1) to the door (4).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fasteners (2) to the inflatable restraint side impact sensor (1) using only hand tools.

    Tighten:  Tighten the fasteners to 10 N.m (89 lb in).

  5. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door (With YE9 Early Production) or Trim Panel Replacement - Side Front Door (With YE9 Late Production) in Doors.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  or to SIR Disabling and Enabling Zone 6 .
About FixVault