Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Install the brake caliper bracket (1).
Perform the following procedure before installing the brake caliper bracket mounting bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the caliper bracket mounting bolts (2).
Tighten:
- Tighten the brake caliper bracket mounting bolts to 175 N.m (121 lb ft) (15 Series).
- Tighten the brake caliper bracket mounting bolts to 300 N.m (221 lb ft) (25 Series).

Fig 1: Brake Caliper Bracket Mounting & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the anti-rattle clips to the brake caliper bracket.
Install the brake pads to the brake caliper bracket.
Slide the brake pads in until they contact the rotor.

Fig 2: View Of Disc Brake Pads & Brake Caliper Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper. Refer to Brake Caliper Replacement - Front .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.
With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
Slowly release the brake pedal.
Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.