FixVault
Home › Cadillac › 2003 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 639 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Instrument Panel Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the I/P module pigtail down through the I/P.
    2. Fig 1: I/P Module Mounting Fasteners
    GM759588Courtesy of GENERAL MOTORS CORP.
  2. Installing I/P module to the instrument panel.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the I/P module mounting fasteners.

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

    4. Fig 2: Routing I/P Module Wiring Harness In Place To Securing I/P Module Yellow 2-Way Connector Clip
    GM759591Courtesy of GENERAL MOTORS CORP.
  4. Route the I/P module wiring harness in place to secure the I/P module yellow 2-way connector clip.
  5. Install the I/P retainer. Refer to Instrument Panel (I/P) Retainer Replacement in Instrument Panel, Gages and Console.
  6. Install the I/P module yellow connector to the vehicle harness yellow connector.
  7. Install the CPA to the instrument panel module connector.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
  9. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping  for proper disposal.
About FixVault