Installation Procedure
WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove any dirt, grease, or other impurities from the mounting surface.
- Install the mounting fasteners to the inflatable restraint roof rail module.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
- Install the roof rail module harness connector (1) to the wiring harness.
- Install the CPA to the roof rail module harness connector.
- Install the windshield garnish molding. Refer to Garnish Molding Replacement - Windshield Pillar in Interior Trim.
- Install the center pillar garnish moldings. Refer to Garnish Molding Replacement - Center Pillar in Interior Trim.
- Install the rear sail panel. Refer to Sail Panel Replacement in Interior Trim.
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 .
- Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
CAUTION:
Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
NOTE:
Refer to Fastener Notice in Cautions and Notices.