Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Install a new inflatable restraint side impact module bracket.

CAUTION: Following the deployment of a side impact air bag, replace the inflator module bracket to the air bag. Failure to do so may cause future personal injury.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 bracket mounting bolts to the module.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 1: Inflatable Restraint Side Impact Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (1) to the inflatable restraint side impact module.
Install the connector position assurance (CPA) to the module electrical connector.
Install the module to the seat.

Fig 2: Inflatable Restraint Side Impact Module Bolts

Courtesy of GENERAL MOTORS CORP.

Install the 2 bolts (1) to the inflatable restraint side impact module.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 3: Seat Back Panel Cover & Seat

Courtesy of GENERAL MOTORS CORP.

Install the seat back panel (2) to the seat (1) by sliding the bottom of the panel into place and pushing the top of the panel in until the push-in retainers are secure.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 for driver's seat or SIR Disabling and Enabling Zone 9 for passenger seat.
Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .