FixVault
Home › Cadillac › 2003 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 669 (Front Suspension System) › Repair Instructions › Shock Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Shock Module To Vehicle
    GM742957Courtesy of GENERAL MOTORS CORP.
  1. Install the shock module to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the shock module upper mounting bolts.

    Tighten:  Tighten the bolts to 112 N.m (83 lb ft).

    3. Fig 2: Positioning Air Conditioning Line Bracket To Stud
    GM847731Courtesy of GENERAL MOTORS CORP.
  3. Position the air conditioning line bracket to the stud.
  4. Install the air conditioning line retaining nut to stud.

    Tighten:  Tighten the nut to 9 N.m (80 lb in).

  5. Raise the vehicle.
    6. Fig 3: Installing Shock Module Lower Mounting Bolts
    GM742959Courtesy of GENERAL MOTORS CORP.
  6. Install the shock module lower mounting bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    7. Fig 4: Connecting Upper Ball Joint To Steering Knuckle
    GM750897Courtesy of GENERAL MOTORS CORP.
  7. Connect the upper ball joint to the steering knuckle.
  8. Install the upper control arm to steering knuckle pinch bolt and nut.

    Tighten:  Tighten the bolt to 60 N.m (44 lb ft).

  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
About FixVault