Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Install the coil spring to the vehicle.
Raise the cradle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Fig 1: Installing Frame To Body Mounting Bolts And Washers

Courtesy of GENERAL MOTORS CORP.

Install the frame to body mounting bolts (4) and washers (3).
Tighten:
- Tighten the front bolts to 265 N.m (195 lb ft).
- Tighten the rear bolts to 191 N.m (141 lb ft).
Remove the jack from the vehicle.

Fig 2: Installing Suitable Jack Under Lower Control Arm

Courtesy of GENERAL MOTORS CORP.

Install a suitable jack under the lower control arm.
Using the jack raise the lower control arm until the shock absorber aligns with the knuckle.

Fig 3: Installing Shock Absorber Lower Retaining Bolt

Courtesy of GENERAL MOTORS CORP.

Install the shock absorber lower retaining bolt.
Tighten: Tighten the bolt to 150 N.m (111 lb ft).
Remove the jack from the vehicle.

Fig 4: Installing Brake Pipe Bracket To Mounting Studs

Courtesy of GENERAL MOTORS CORP.

Install the brake pipe bracket (2) to the mounting studs (1).
Install the brake pipe bracket retaining nuts.
Tighten: Tighten the nuts to 10 N.m (89 lb in).
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Lower the vehicle.