FixVault
Home › Cadillac › 2003 › Seville SLS › Repair and Diagnosis › External Pages › Different car › Section 509 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Instrument Panel Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Restraint Module Mounting Fasteners
    GM427782Courtesy of GENERAL MOTORS CORP.
  1. When installing the inflatable restraint module (3), do not damage the pigtail and the connector (4).
  2. Route the module pigtail (4) down through the I/P (1).
  3. Install the inflatable restraint module (3) to the I/P.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the mounting fasteners (2) to the inflatable restraint I/P module.

    Tighten:  Tighten fasteners to 9 N.m (80 lb in).

    5. Fig 2: Identifying Inflatable Restraint Module & Yellow Connector
    GM464929Courtesy of GENERAL MOTORS CORP.
  5. Route the module wiring harness (2) in place to secure the yellow connector clip to the I/P (3).
  6. Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
    7. Fig 3: View Of I/P, Module Yellow Connector & CPA
    GM464940Courtesy of GENERAL MOTORS CORP.
  7. Clip the yellow connector (2) to the I/P bracket (3).
  8. Install the yellow connector (2) on the inflatable restraint I/P module to the yellow connector (1) on the vehicle harness.
  9. Install the CPA (4) to the inflatable restraint I/P module connector (2).
  10. Install the right insulator panel. Refer to Closeout/Insulator Panel Replacement - Right (LHD) or Closeout/Insulator Panel Replacement - Right (RHD) in Instrument Panel, Gages and Console.
  11. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .
About FixVault