FixVault
Home › Cadillac › 2003 › Seville SLS › Repair and Diagnosis › External Pages › Different car › Section 519 (Front Suspension System) › Repair Instructions › Strut, Strut Component and/or Spring Replacement › Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the coil spring and upper strut mount to the J 45400  . See Special Tools and Equipment .
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
    Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
  3. Install the strut to the coil spring and upper strut mount.
    4. Fig 2: Removing/Installing Strut Retaining Nut
    GM1079158Courtesy of GENERAL MOTORS CORP.
  4. Loosely install the strut retaining nut.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Use a 45 TORX® socket in order to hold the strut shaft. Use the J 42991  to Install the upper strut mount nut. See Special Tools and Equipment .

    Tighten:  Tighten the strut mount nut to 85 N.m (63 lb ft).

  6. Remove the strut from the J 45400  . See Special Tools and Equipment .
  7. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
About FixVault