FixVault
Home › Cadillac › 2004 › CTS V › Repair and Diagnosis › Engine Performance › System › Engine Controls - 5.7L - Introduction › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor retaining bolt.

    Tighten:  Tighten the CKP sensor to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
  4. Install the starter. Refer to Starter Motor Replacement (LA3, LY9) , Starter Motor Replacement (LY7) or Starter Motor Replacement (LS6) in Engine Electrical.
  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure .
About FixVault