FixVault
Home › Cadillac › 2004 › DeVille Protection Series › Repair and Diagnosis › Steering › Steering Wheel And Steering Column › Repair Instructions › Ignition Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Ignition Lock Cylinder Case, Ignition Switch, Retaining Screws & Key Alarm Connector
    GM324871Courtesy of GENERAL MOTORS CORP.
  1. Install the lower case ignition switch (2) to the steering column.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition switch retaining screws (3).

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  3. Connect the ignition switch electrical connectors.
    4. Fig 2: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  4. Install the theft deterrent module (2) to the ignition lock cylinder case (1).
  5. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement (Power Tilt)  or Steering Column Trim Covers Replacement (Manual Tilt) .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
About FixVault