FixVault
Home › Cadillac › 2004 › DeVille Protection Series › Repair and Diagnosis › Steering › Steering Wheel And Steering Column › Repair Instructions › Ignition Switch Replacement › Removal Procedure

Removal Procedure

    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement (Power Tilt)  or Steering Column Trim Covers Replacement (Manual Tilt) .
    3. Fig 1: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS CORP.
  3. Remove the theft deterrent module (2) from the ignition lock cylinder case assembly (1).
  4. Disconnect the ignition switch electrical connector.
    5. Fig 2: View Of Ignition Lock Cylinder Case, Ignition Switch, Retaining Screws & Key Alarm Connector
    GM324871Courtesy of GENERAL MOTORS CORP.
  5. Remove the key alarm connector (1) from the ignition lock cylinder case (4).
  6. Remove the ignition switch retaining screws (3).
  7. Remove the lower case ignition switch (2).
About FixVault