FixVault
Home › Cadillac › 2004 › Escalade EXT › Repair and Diagnosis › Restraints › Air Bag, SRS › Supplemental Inflatable Restraint System › Repair Instructions › Inflatable Restraint Side Impact Module Replacement - Front › Installation Procedure

Installation Procedure

    Fig 1: View Of Side Impact Module, Wiring Harness & Seat Frame
    GM628565Courtesy of GENERAL MOTORS CORP.
  1. Install the module wiring harness (2) to the seat frame (3) while guiding the wiring harness through the appropriate spots on the seat frame.
  2. Install the wiring harness retaining clips to the seat frame.
    3. Fig 2: View Of Inflatable Restraint Side Impact Module & Bolts
    GM624131Courtesy of GENERAL MOTORS CORP.
  3. Install the side impact module (1) to the seat frame.
  4. Install the side impact module retainer.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the retaining bolts (3) to the side impact module.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  6. Install the seat back cover. Refer toSeat Back Cover and Pad Replacement - Front (W/O ULT) or Seat Back Cover and Pad Replacement - Front (W/ULT) in Seats.
  7. Install the front seat. Refer to Seat Replacement - Front Bucket in Seats.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7  and SIR Disabling and Enabling Zone 9 .
About FixVault