FixVault
Home › Cadillac › 2004 › Escalade EXT › Repair and Diagnosis › Steering › Electronic Steering › Rear Wheel Steering System › Repair Instructions › Steering Gear Protection Shield Replacement › Installation Procedure

Installation Procedure

    Fig 1: Steering Gear Protection Shield
    GM742182Courtesy of GENERAL MOTORS CORP.
  1. Install the steering gear protection shield to the steering gear.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the steering gear protection shield retaining bolts (3) to the steering gear.

    Tighten:  Tighten the bolts to 180 N.m (132 lb ft).

  3. Lower the vehicle.
  4. Perform a four wheel alignment. Refer to Measuring Wheel Alignment (w/Rear Wheel Steering) or Measuring Wheel Alignment (w/o Rear Wheel Steering) in Wheel Alignment.
About FixVault