Removal Procedure

Tools Required

• J 6632-01  Pitman Arm Puller. See Special Tools and Equipment .
• J 24319-B  Universal Steering Linkage Puller. See Special Tools and Equipment .
• J 29107-A  Pitman Arm Puller. See Special Tools and Equipment .

1. Place a drain pan under the vehicle.
2. Remove the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement in Frame and Underbody.
NOTE: Refer to Power Steering Hose Disconnected Notice in Cautions and Notices.
3. Remove the power steering hoses from the steering gear.
4. Cap the ends of the hoses and the power steering gear in order to prevent any entrance of dirt.
5. Disconnect the intermediate shaft from the steering gear. Refer to Intermediate Steering Shaft Replacement - Lower in Steering Wheel and Column.
Fig 1: View Of Pitman Arm At Relay Rod Nut
Courtesy of GENERAL MOTORS CORP.
6. Remove the pitman arm to relay rod nut.
Fig 2: Disconnecting Pitman Arm From Relay Rod Using J 24319-B
Courtesy of GENERAL MOTORS CORP.
7. Disconnect the pitman arm from the relay rod using J 24319-B  . See Special Tools and Equipment .
Fig 3: View Of Power Steering Gear & Bolts
Courtesy of GENERAL MOTORS CORP.
8. Remove the bolts retaining the steering gear to the frame.
9. Remove the steering gear from the vehicle.
Fig 4: View Of Pitman Arm, Power Steering Gear, Washer & Nut
Courtesy of GENERAL MOTORS CORP.
10. Remove the pitman arm to the power steering gear retaining nut.
Fig 5: Removing Pitman Arm From Gear Using J 6632-01 Or J 29107-A
Courtesy of GENERAL MOTORS CORP.
11. Remove the pitman arm from the power steering gear using J 6632-01  or J 29107-A  . See Special Tools and Equipment .