FixVault
Home › Cadillac › 2004 › Seville › Repair and Diagnosis › External Pages › Different car › Section 115 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
    2. Fig 1: View Of Inflatable Restraint Side Impact Sensor & Components
    GM457510Courtesy of GENERAL MOTORS CORP.
  2. Installation of passenger or driver inflatable restraint side impact sensor (SIS) use the same procedure.
  3. Install the SIS (2) to the center pillar (3).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the SIS mounting fasteners (1).

    Tighten:  Tighten the fasteners to 9 N.m (80 lb in).

  5. Install the SIS harness connector (4) to the SIS (2).
  6. Install the CPA (5) to the SIS harness connector (4).
  7. Install the center pillar trim. Refer to Garnish Molding Replacement - Center Pillar (Standard) or Garnish Molding Replacement - Center Pillar (WC2, WC8) in Interior Trim.
  8. Move seat to the original position.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 .
About FixVault