FixVault
Home › Cadillac › 2004 › Seville › Repair and Diagnosis › External Pages › Different car › Section 98 (Seat System) › Repair Instructions › Power Recliner Sensor Replacement - Front › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the recliner sensor to the recliner motor.
  2. Slide the recliner shaft back through the recliner sensor and the recliner motor.
    3. Fig 1: View Of Recliner Motor & Recliner Sensor
    GM295194Courtesy of GENERAL MOTORS CORP.
  3. Install the retaining clip to the recliner shaft.
    4. Fig 2: View Of Recliner Motor End Retainer Clip
    GM295189Courtesy of GENERAL MOTORS CORP.
  4. Connect the recliner motor electrical connector.
  5. Install the seat back trim cover. Refer to Seat Back Trim Replacement - Front .
  6. Install the lower seat belt retractor trim cover (2).
  7. Install the push pin fastener (1)
    8. Fig 3: View Of Lower Seat Belt Retractor Trim Cover & Push Pin Retainer
    GM518896Courtesy of GENERAL MOTORS CORP.
  8. Install the front bucket seat. Refer to Seat Replacement - Bucket .
  9. Calibrate the seat. Refer to Memory Seat Calibration Procedure .
About FixVault