FixVault
Home › Cadillac › 2004 › Seville › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle - 4T80-E (Introduction, Service & Replacement) › Repair Instructions › Shift Control Replacement › Removal Procedure

Removal Procedure

  1. Remove the console trim plate. Refer to Trim Plate Replacement - Console in Instrument Panel, Gages, and Console.
    2. Fig 1: View of Shift Cable Terminal
    GM291754Courtesy of GENERAL MOTORS CORP.
  2. Unsnap the shift cable terminal from the shifter pin.
  3. Remove the shift cable bolt and cable from the shifter.
    4. Fig 2: View of Automatic Transmission Shift Lock Actuator Solenoid
    GM291741Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the automatic transmission shift lock actuator wire harness connector, from the automatic transmission shift lock actuator solenoid.
  5. Disengage the locking tab on the park lock cable and lift the cable out of the slot in the shifter.
  6. Unhook the park lock cable from the park lock cam on the shifter.
    7. Fig 3: View of Shifter Assembly
    GM291888Courtesy of GENERAL MOTORS CORP.
  7. Remove the shifter fasteners.
  8. Spread the console side panels apart and remove the shifter assembly.
About FixVault