FixVault
Home › Cadillac › 2004 › Seville › Repair and Diagnosis › Transmission › Automatic Trans › Shift Interlock System › Repair Instructions › Automatic Transmission Shift Lock Actuator Replacement › Removal Procedure

Removal Procedure

  1. Remove the console trim Plate. Refer to Trim Plate Replacement - Console in Instrument Panel, Gages and Console.
    2. Fig 1: View of Anti-theft Plate
    GM301685Courtesy of GENERAL MOTORS CORP.
  2. If equipped with RPO Code (T1A), remove the anti-theft plate and tamper proof fastener from the shifter using the J 43146  . See Special Tools and Equipment .
    3. Fig 2: View of Automatic Transmission Shift Lock Actuator Solenoid
    GM291741Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the automatic transmission shift lock actuator wire harness connector, from the automatic transmission shift lock actuator solenoid.
  4. Disengage the locking tab on the park lock cable and lift the cable out of the slot in the shifter.
  5. Unhook the park lock cable from the park lock cam on the shifter.
  6. Turn the ignition switch to the run position.
    7. Fig 3: Identifying Cable Locking Tab
    GM339402Courtesy of GENERAL MOTORS CORP.
  7. Depress the locking tab (1) on the cable and pull the cable out of the back of the ignition switch. The locking tab is located on the bottom of the ignition switch facing in the 6 o'clock position
    8. Fig 4: View of Park Lock Cable
    GM291738Courtesy of GENERAL MOTORS CORP.
  8. Remove the park lock cable from the vehicle.
About FixVault