FixVault
Home › Cadillac › 2004 › XLR › Repair and Diagnosis › Electrical › Instrument Panel System Displays, Gauges And Console › Repair Instructions › Ignition Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of DIC Switch Pod
    GM1224702Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch into position on the DIC pod.
    2. Fig 2: View Of Ignition Switch & Electrical Connector
    GM1224598Courtesy of GENERAL MOTORS CORP.
  2. Connect the ignition switch electrical connections.
    3. Fig 3: View Of DIC Switch Pod
    GM1224702Courtesy of GENERAL MOTORS CORP.
  3. Install the DIC switch pod. Refer to Driver Information Center Switch Replacement .
  4. Install the driver knee bolter trim panel. Refer to Trim Panel Replacement - Knee Bolster .
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Connect the negative battery cable.

    Tighten:  Tighten the cable bolt to 15 N.m (11 lb ft).

About FixVault