FixVault
Home › Cadillac › 2005 › CTS Base, 2.8 T, Automatic › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transmission - Introduction & Repair Instructions › Repair Instructions › Shift Control Knob Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Shift Knob
    GM891699Courtesy of GENERAL MOTORS CORP.
  1. Install the shift knob fully onto the shift control shaft.
    2. Fig 2: Identifying Shift Knob Retaining Screw
    GM891696Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. If previously removed, install the shift knob retaining screw.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

    3. Fig 3: Installing Shift Knob Trim Ring
    GM891694Courtesy of GENERAL MOTORS CORP.

  3. Install the shift knob trim ring to the shift knob.

About FixVault