FixVault
Home › Cadillac › 2005 › CTS V › Repair and Diagnosis › Engine Performance › System › Engine Controls - 5.7L - Introduction › Repair Instructions › Crankshaft Position (CKP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CKP sensor retaining bolt.

    Tighten:  Tighten the CKP sensor to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
  4. Install the starter. Refer to Starter Motor Replacement (LP1, LY7) or Starter Motor Replacement (LS6) in Engine Electrical.
  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  7. Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure 
About FixVault