FixVault
Home › Cadillac › 2005 › CTS V › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Engine Controls - 3.6L - Introduction) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Tank Pressure Sensor Electrical Connector
    GM1558059Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the fuel tank pressure sensor electrical connector (1).
    3. Fig 2: Removing/Installing Fuel Tank Pressure Sensor
    GM1558061Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: There are alignment features on the canister, however, there are no locking tabs on the sensor/canister. The sensor is held into the canister by the tight fit of the multi-lip seal.
  3. Remove the fuel tank pressure sensor from the evaporative emission (EVAP) canister.
About FixVault