FixVault
Home › Cadillac › 2005 › CTS V › Repair and Diagnosis › Steering › Steering Wheel And Steering Column › Repair Instructions › Ignition Switch Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Ignition Switch, Electronic Lock Module & J 42759
    GM664261Courtesy of GENERAL MOTORS CORP.
  1. Insert J 42759 into the ignition lock cylinder case assembly (1) and slide the ignition switch assembly (2) in.
  2. Connect the connector to the ignition switch assembly (2).
    3. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR INFLATOR MODULE COIL CAUTION in Cautions and Notices.
  3. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
  4. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  5. Install the wires back into the ignition switch clip.
  6. Install the theft deterrent control module. Refer to Theft Deterrent Control Module Replacement in Theft Deterrent.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
About FixVault