FixVault
Home › Cadillac › 2005 › DeVille Base › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Camshaft Position Sensor Retaining Bolt
    GM602301Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the camshaft sensor o-ring for wear or damage. If a problem is found, replace the o-ring.
  1. Lubricate the camshaft o-ring with engine oil.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the camshaft sensor and retaining bolt.

    Tighten:  Tighten the retaining bolt between 10 N.m (89 lb. in.).

  3. Reconnect the camshaft sensor electrical connector.
  4. Operate the engine and inspect the camshaft sensor for engine oil leaks.
About FixVault