FixVault
Home › Cadillac › 2005 › DeVille Protection Series › Repair and Diagnosis › Engine Performance › System › Engine Controls - Introduction › Repair Instructions › Manifold Absolute Pressure (MAP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: MAP, IAC, ECT, TP Sensors Component View
    GM602335Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP (1) sensor into the intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the accelerator control cable bracket and bolts.

    Tighten:  Tighten the bracket bolts to 12 N.m (106 lb. in.).

  3. Connect the MAP sensor electrical connector.
About FixVault